Aeg-Electrolux L61470WDBI User Manual download pdf (Page 25)

3. 4.

45°

20°

14.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Place the end of the emergency

emptying hose and that of the inlet

hose in a bowl placed on the floor

and let water flow out of the hoses.

4. Set the Drain programme and let it

operate until the end of the cycle.

5. Turn the programme knob to Ein/Aus

to disconnect the appliance from the

power supply.

6. Screw the water inlet hose back on

and re-fit the emergency emptying

hose after having put the cap on

again.

WARNING!

Make sure that the

temperature is more than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

15. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

15.1 Introduction

The start of the appliance does not occur

or it stops during operation.

First try to find a solution to the problem

(refer to the table). If not, contact the

Authorised Service Centre.

With some problems, the acoustic

signals operate and the display shows

an alarm code:

• - The appliance does not fill with

water properly.

• - The appliance does not drain

the water.

• - The appliance door is open or

not closed correctly. Please check the

door!

•

- The mains supply is unstable.

Wait until the mains supply is stable.

•

- No communication between

electronic elements of the appliance.

Switch off and switch on again.

• - The anti-flood device is on.

Disconnect the appliance and close

the water tap. Contact the Authorised

Service Centre.

WARNING!

Deactivate the appliance

before you do the checks.

ENGLISH 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Comments to this Manuals

No comments