AEG Electrolux ESL 2435 Specifications download pdf (Page 19)

- 19 -

Installation

Fitting the outer door

1. Unscrew the screws on the mounting plate. Lift

the plate off together with the door.

2. Lay the machine down on its back. Check that

none of the hoses are trapped. Insert the guide

rods into the plastic door guides.

3. Slot the tabs on the mounting plate into the

holes on the front plinth of the machine and

screw the mounting plate into place using the

2 screws provided.

Fitting protective and inﬁll strips

In order to ﬁll the gap between the cupboard and the dish-

washer and to protect the cupboard above from any steam

that comes out of the washer, a self-adhesive protective

strip is attached along the upper edge of the cupboard

and two inﬁll strips are attached along the edge of the

cupboard.

1. Clean all surfaces where the strips are to be

attached to ensure better adhesion.

2. Attach the protective strip along the upper edge

of the cupboard. If it is too long, it can easily be

cut to the right length.

3. Attach the two inﬁll strips along each side of the

cupboard, level with the front edge of the sides.

Tab

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

AEG Electrolux ESL 2435 Specifications Page 19