Aeg-Electrolux PE9038-A User Manual Page 1

ENGLISH CONTENTS 1. Safety instructions 2. Description of the coffee machine 3. Description of the control panel: touch control 4. Instruction

• Ensure the mains ON/OFF switch(at rear) is ON • push the machine back into the housing until a “CLICK” can be heard. This indicate that the mach

• Pour approximately 200g of coffee beans into the container on the top as shown in the figure. • Push the machine back into the h

• • The machine is be in stand-by mode when the ON-OFF LED is blinking slowly, it is then ready to be switched on. • Ensuring the water reser

• Pull the coffee machine forward from it’s housing by sliding it along it’s telescopic runners. • Turning the knob will adjust the coffee

STAND-BY MODE• Once powered and inserted into the cabinet, the machine is in stand-by mode: this will be signaled by the on/off LED blinking. • Pr

5 MAKING COFFEE • Press the control corresponding to the desired selection. • Press the start control within 10 seconds and the machine will ma

6 HOT WATER • The steam/water pipe can be moved to the back of the cabinet when not in use. Pull forward when required. Do not touch when HOT!

7 STEAM HEATING LIQUIDS • Press the steam control and the corresponding indicator blinks for 20 seconds. The machine will be ready to make steam

8 PROGRAMMING THE AMOUNT OF COFFEE BEANS TO BE GRINDED • This espresso machine has already been calibrated in factory to dispense the ideal measure

• Once you have modified the coffee ground quantity, press the start control for 10 seconds and the machine will automatically save the quantity d

1. SAFETY INSTRUCTION Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in th

9 PROGRAMMING THE VOLUME OF COFFEE DISPENSED IN THE CUP • The volume of coffee dispensed can be adjusted as desired as follows: • Press the espre

10 IF YOU WISH TO RESET THE STANDARD VALUES RESETTING STANDARD VALUES • This coffee machine is calibrated in the factory to make the optimum Ital

11 SIGNAL AND ALARMS WATER REFILL INDICATOR • This machine has a sensor which detects when the water reservoir is empty. the reservoir empty le

FAULT INDICATOR • The machine incorporates an automatic system that, detecting a fault in operation, will illuminate all the LEDS. Switch OFF the m

13 CLEANING OUTER PARTS • Clean the stainless steel parts of the machine with a soft cloth without using aggressive detergents. Never use any abra

DRIP TRAY 26/35 • Remove the drip tray from the machine as it is shown in the figures above. • Remove the drip tray from the machine as it is

Pull open the door and remove the drawer and empty it. The drawer can be washed in a dishwasher or simply with hot water. Replace the dra

28/35WATER RESERVOIR • If the machine is not used for long periods, change the water in the reservoir and drain the boiler by pressing the coffee b

14 INSTALLATION BUILDING-IN Installing the machine into kitchen furniture with proper characteristics will ensure a correct operation of the equipme

ELECTRICAL CONNECTION • Fix the power cable onto the left side of the cabinet using one of the self-threading screws of the equipment and the

FOR INSTALLATION AND SERVICING Keep this instruction manual together with the machine for any future reference. If the machine is sold or transferred

31/35 • Connect the power cable as shown in the figure. This machine is designed for a single phase voltage of 230V. The power supply requires on

• Τhey should be used to compensate for the internal width of the compartment, leading to a width of 560/570 mm. • Fix the U

• Slide the machine into the cabinet until the “click” indicates that it is locked into Position. 15 SOMETHING NOT WORKING... If this ma

34/3517 AFTER-SALES SERVICE, SPARE PARTS AND GUARANTEE SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, cont

35/35GUARANTEE CONDITIONS AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 24 months comme

CE This machine complies with the directive BT 73/23 Electrical safety rules EN 60335-1 (August 1995 - Safety for electrical household and similar ap

THE PLUG MUST STILL BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN INSTALLED. THE APPLIANCE SHOULD NOT BE CONNECTED TO THE ELECTRICAL SUPPLY BY MEANS O

2. DESCRIPTION OF THE COFFEE MACHINE 1. Water reservoir 2. Brita filter 3. Coffee Outlet 4. Steam/water nozzle 5. Drip tray 6. Coffee beans co

3. DESCRIPTION OF THE CONTROL PANEL: TOUCH CONTROLS 1. Water refill indicator 2. ON-OFF/stand-by indicator 3. Start indicator 4. Hot water

4 INSTRUCTIONS FOR THE FIRST USE OF THE MACHINE FILLING UP THE WATER RESERVOIR • Squeeze together the unlocking levers found under the drip

Hardness of water: • Before filling up the water reservoir, make sure that the decalcifying Brita filter has been soaked in cold water for at least 3