Aeg-Electrolux L14950A User Manual download pdf (Page 16)

unfold the rolled up items, redistribute them evenly in the drum and select an addi-

tional drying cycle of 20-30 minutes.

6. At the end of the drying programme, the buzzer sounds. A blinking «0» appears on the

display. At this point, begins an anti-crease phase which lasts for about 10 minutes.

During this time the ANTI-CREASE symbol appears on the display. The DOOR symbol

remains lit. The door cannot be opened.

If you need to open the door before or during the anti-crease phase or to interrupt it, press

any button or turn the programme selector dial to any programme position (except O), the

door can be opened immediately or after a few minutes depending on the model. (In any

case do not try to open the door if it is locked!) .

7. Turn the selector dial to the O position to switch the machine off.

8. Remove the laundry.

Automatic washing and drying (NON-STOP programme)

For NON-STOP programmes, the recommended load size is 4 kg for cotton and 3 kg for syn-

thetic.

It is possible to dry up to 6 kg of cotton items by pressing the Drying Time button only (see

the «Drying Programme » table).

CAUTION!

Do not use a dosing device/ball when carrying out a washing and drying pro-

gramme.

1. Load the laundry.

2. Add detergent and fabric softener.

3. Switch the machine on by turning the selector dial to the selected washing pro-

gramme/fabric.

4. Select the required options by pressing the relevant buttons.

If possible, do not select a spin speed lower than that proposed by the appliance to avoid

too long a drying time therefore saving energy.

In any case the reduction of the spin speed is only possible after selecting drying.

The lowest values you can select are the following:

– 900 r.p.m. for cottons and synthetic with electronic drying;

– 900 r.p.m. for cottons and 700 r.p.m. for fabrics with timed drying.

5. Select a drying time by pressing button 4 or the dryness degree by pressing button 3.

The display shows the entire duration of the washing and the selected drying cycle.

If you set a washing programme and only 10 minutes of drying cycle by pressing the button

4, the total duration displayed includes also the unrolling and the cooling phase.

6. Start the programme by pressing button 7. After the programme has started, the time

remaining is updated every minute.

7. At the end of the programme, follow the indications given in the corresponding previ-

ous chapter.

8. Remove the laundry.

16 Use - Drying

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

No comments

Aeg-Electrolux L14950A User Manual Page 16