AEG Electrolux CaFamosa Operations Instructions download pdf (Page 8)

g

21

The individual water hardness settings

(degrees German hardness, ° dH) are

indicated as follows:

The “Descale“ indicator flashes

( ), in addition the following indica-

tors illuminate ()

for setting 1 (1°-7° dH): “1 Strong

Cup“

for setting 2 (8°-15° dH): “1

Strong Cup“ and “Ground Coffee“

for setting 3 (16°-23° dH): “1

Strong Cup“, “Ground Coffee“

and “Spent Coffee“

for setting 4 (24°-30° dH): “1

Strong Cup“, “Ground Coffee“,

“Spent Coffee“ and “Clean“

for setting 0: no further indicators

illuminate. The automatic descale indi-

cator is switched off.

Note: The water hardness setting is

only to be adjusted prior to using the

appliance for the first time, or if the

quality of the water used changes.

1.4. Adjusting the Safety

Cut-Out

If the appliance is not used for an

extended period of time, it switches

itself off for safety reasons and to save

energy.

The appliance has 3 timer settings;

after the expiry of the time set, the

appliance switches off automatically.

The middle setting 2 (switch off after

2 hours), is set in the factory.

You can change this setting as follows:

0 Plug the appliance into the mains.

0 Do not switch on the appliance.

0 Press the “2 Cups“ button for

approx. 3 seconds. The “Flush“

indicator illuminates.

0 Pressing the “2 Cups“ button again

adjusts the timer setting by one step to

3, 1, 2 and so on.

0 To save the safety cut-out setting and

end the procedure, press the “On/

Off“ button. All indicators go out.

If a button is not pressed for more than

30 sec., the procedure is automatically

ended without changing the value

saved previously.

The individual timer settings are indi-

cated as follows:

The “Flush“ indicator flashes, in

addition the following indicators illu-

minate

for setting 2 (switch off after 2

hours): “Water Tank“ and

“Spent Coffee“

for setting 3 (switch off after 5

hours): “1 Strong Cup“,

“Ground Coffee“, “Clean“,

“Water Tank“ and “Spent Coffee“

for setting 1: no further indicator illu-

minates, the automatic cut-out is not

activated.

2. Prior to Making Coffee

2.1. Filling the Water Tank

(Figure 4)

Open the lid (Figure 1/A) and remove

the water tank by the handle. Please

only use cold, clear water, and do not

fill beyond the MAX mark.

Then refit the water tank in the appli-

ance and press it down until it engages

so the valve on the base is opened.

For aromatic coffee, you should:

• Change the water in the tank daily,

• Not use mineral or distilled water and

• Clean the water tank at least once a

week in normal washing up water (not

in a dishwasher). Then rinse with clean

water.

Incidentally: When the “Water

Tank“ indicator (Figure 2/N) illumi-

nates, your appliance is signalling to

you that the water tank must be

refilled.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Comments to this Manuals

No comments