Aeg-Electrolux B8871-4-A UK R07 User Manual download pdf (Page 58)

Electrical Connection58

Electrical Connection

The oven is designed to be connected to 230240V~(50Hz) electricity supply.

The oven has an easily accessible terminal block which is marked as follows:

1 This oven must be earthed!

The cable used to connect the oven to the electrical supply must

comply to the specifications given below.

For UK use only

It is necessary that you install a double pole switch between the oven and the

electricity supply (mains), with a minimum gap of 3mm between the switch

contacts and of a type suitable for the required load in compliance with the cur

rent regulations.

The switch must not break the yellow and green earth cable at any point.

Important

After installation and connecting, the cable must be placed so that it cannot at

any point reach a temperature of more than 50°C above the ambient tempera

ture.

Before the oven is connected, check that the main fuse and the domestic instal

lation can support the load; and that the power supply is properly earthed.

The manufacturer declines any responsibility should these safety meas

ures not be carried out.

Letter L  Live terminal

Letter N  Neutral terminal

E  Earth terminal

Connection

via

Min. size

Cable/flex

type

Fuse

Cooker Control Circuit 2,5 mm

PVC/PVC

twin and earth

min: 15A

max: 20A

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

No comments

Aeg-Electrolux B8871-4-A UK R07 User Manual Page 58